By A Mystery Man Writer
Any idea why the base of supports sometimes prints super thick
Creality Launches Huge CR-M4 - The Next Big Thing in Quality
Sailboat - no supports - 3D model by 3dprintbunny on Thangs
Clear Solutions
New to printing. My model came out with really thick supports. And it's a huge pain to remove. Any tips I've been at it for about an hour with little progress.
Epson EcoTank ET-8500 - Photo Review
Threads on better support settings, far to aggressive. : r/prusa
Supports printed very thick : r/resinprinting
Better/Faster 3D Printing with Cura Settings Guide
Thick Wall (6 loops) Fails at 45 Degree Angle - Troubleshooting
Printing 3D Printer
Why your resin printer only prints supports and no model, and how
3D printers: What can you print and should you buy one? - Consumer NZ
3D Printing Supports: 3 Simple Steps to Success
Are these too many supports? Also, it comes out smooth but after a