PETG finish changes mid print - Troubleshooting - Bambu Lab Community Forum

What would cause this kind of finish change in the middle of a print?

Ultimaker Support Just looking for some advice what I can change

Flushing Volumes Calibration - V2 and new Gcode by AMT_MW - MakerWorld

PETG 3D Printing: Everything You Need to Know About PETG Filament

Bambu Lab X1 Carbon PETG Settings - Get Perfect Prints

Bambu Lab 3D Printers Users Group

Creality PETG 3D Printing Filament 1.75mm, Excellent

P1P Problems printing eSun PETG : r/BambuLab

PETG finish changes mid print - Troubleshooting - Bambu Lab

10 Tips for Improving the Accuracy of 3D Printing

There was an attempt at using PETG as support for PLA : r/BambuLab

I finally found my perfect petg support settings. : r/3Dprinting

Bambu Lab PETG Basic - Troubleshooting - Bambu Lab Community Forum

Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P