By A Mystery Man Writer
Hey guys so since I did the last update to be at the latest firmware my first layer is lost it’s textured finish. I tried reverting to the previous firmware and still same issue. Support asked to to check the belt tension, recalibrate and manual level. Now I’m found calibration on the K value but the one value that looks best has problems with adhesion and one corner will lift lol, if I change it back to default it will print with no lift lol. Any other ideas from the group as to what I should t
Bad printing quality with PETG - Troubleshooting - Bambu Lab Community Forum
P1P randomly stopped working well (SOLVED) - Troubleshooting - Bambu Lab Community Forum
First layer ugly only in one part - Troubleshooting - Bambu Lab Community Forum
Prusa MK3S+ vs Bambu Lab X1 carbon - Page 12 – General discussion, announcements and releases – Prusa3D Forum
Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800
P1P Infill Tearing - Troubleshooting - Bambu Lab Community Forum
New p1p first layer issues. : r/BambuLab
New p1p first layer issues. : r/BambuLab
Has anyone had direct experience use JB Weld on metal to PLA