By A Mystery Man Writer
Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin
First Print - Troubleshooting - V1 Engineering Forum
Myriad of First Layer Issues {MK3S+} : r/prusa
Help! First Layer Issues – Assembly and first prints
Troubleshooting 3D prints, first layer issues
V1 Engineering Inc -V1E.com
First Print - Troubleshooting - V1 Engineering Forum
3D Printing Layer Issues - Advice - V1 Engineering Forum
First Layer Problems – Assembly and first prints troubleshooting
First Layer Problems – Assembly and first prints troubleshooting
V1 Engineering Inc -V1E.com
First Layer Frustrations – Assembly and first prints