PSS Hose Barb Plug - PYI Inc.

Description Documents Description This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented" or you can use this plug in place of the hose barb that's inserted into the carbon stator. "Burping" The PSS Shaft Seal You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless steel rotor. This will cause a quick mist of water to spray out. Important If your boat will exceed 10 knots under power then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling

PYI Inc Fisheries Supply

Description, Documents, Description, This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS

PSS Hose Barb Plug

PSS Shaft Seal 1 1/2 Shaft & 2 1/4 Shaft Log/Stern Tube, 02-112-214, PYI Inc : Industrial & Scientific

PSS T-Kit - PYI Inc.

PYI PSS PRO Shaft Seals

PYI Inc. PSS Shaft Seal

PSS installation instructions (low res).pdf - PYI Inc.

PYI Inc. PSS Type C Shaft Seal

These T-Kits enable the installer to tee into the raw water discharge hose and plumb water to the hose barb fitting of the PSS Shaft Seal.

T-Kit

Installing a PSS Shaft Seal - Marine How To

PSS Hose Barb Plug - PYI Inc.

Installing a PSS Shaft Seal - Marine How To

PYI Inc. PSS Type C Shaft Seal