M4 x 0.7mm Nylock Nut (25 Pack) - ServoCity®

These M4 locknuts have a nylon insert that the threads of a mating screw must form threads in upon insertion.  The displaced nylon will continue to hold tension on the screw threads which act as a locking mechanism to prevent the screw from loosening under vibration.  While M4 is not a go-to in Actobotics®, they are sometimes necessary to have when utilizing parts from our metric build-system, goBILDA®.

4mm ID Aluminum Spacer (8mm OD, 43mm Length) - 4 Pack - ServoCity®

2804 Series Zinc-Plated Steel Low Profile Socket Head Screw (M4 x 0.7mm, 8mm Length) - 25 Pack

1526 Series 32mm OD Plastic Pattern Spacer (10mm Length) - 2 Pack

1106 Series Square Beam (4 Hole, 32mm Length) - ServoCity®

Plastic Servo Hub (H25T Spline, 32mm Diameter)

1616 Series Drop-Center Bearing Plate (2mm Drop) - 4 Pack

1804 Series Servo Stand (32-1) - ServoCity®

2913 Series Steel Ball Linkage (Male M4 x 0.7mm, 29.4mm Length) - 2 Pack - ServoCity

2901 Series Shock Mount (1-1) - 2 Pack - ServoCity

2808 Series Stainless Steel Threaded Rod (M4 x 0.7mm, 100mm Length) - 2 Pack

2802 Series Zinc-Plated Steel Button Head Screw (M4 x 0.7mm, 16mm Length) - 25 Pack - ServoCity

2901 Series Shock Mount (1-1) - 2 Pack - ServoCity

2901 Series Shock Mount (1-1) - 2 Pack - ServoCity

Split-lock washers flatten as a screw or nut is tightened, which creates tension between the head and the surface under the washer. This tension

2809 Series Zinc-Plated Steel Split-Lock Washer (4mm ID x 7mm OD) - 25 Pack

7mm Combination Nut Driver - ServoCity