3 LIFT KIT (STEEL SPRING) - Q7 (2007-2015) – Eurowise Performance

By A Mystery Man Writer

Eurowise 3 inch Lift Kit for the Audi Q7 is a combination of our spacer lift and our 1" subframe drop. Machined from 6061 aluminum solid block, these lift kits will never wear out or fail. In addition, we include 1" subframe drop to correct your axle geometry. This is a direct bolt on lift kit that installs over the to
Eurowise 3 inch Lift Kit for the Audi Q7 is a combination of our spacer lift and our 1 subframe drop. Machined from 6061 aluminum solid block, these lift kits will never wear out or fail. In addition, we include 1 subframe drop to correct your axle geometry. This is a direct bolt on lift kit that installs over the top of the OEM Struts on (ONLY COIL SUSPENSIONS). Very straight forward installation process requires removal of front and rear strut assembly and bolt on installation along with dropping front and rear subframe. Front or Rear springs do not need to be compressed. No specialty spring compressor tools are needed for the install of our GEN 1 Lift Kits. For air suspension cars see: Air Suspension Lift Kit Professional installation highly recommended. FITMENT: Audi Q7 (2007-2015) INSTALLATION GUIDE Axle Angle on Level Ground: Spacer Installed on Strut: Subframe Spacer Installed: Axle Angle Full Droop: Axle Angle after Subframe Drop at Full Droop: Rear springs do not need to be compressed. No specialty spring compressor tools are needed for the install of our GEN 1 lift kits. Add optional upper control arms to properly dial suspension alignment in. 3 of lift will result in about 1-1.5 degrees of positive camber after installing 3inch and more of lift. We designed these upper control arms proprietary to our 3 inch lift kits for steel spring and air ride chassis to dial in the alignment back to factory specs. Not only do they perform better than stock they look good too. Link to Product Offroad Build Gallery: Click Here