By A Mystery Man Writer
Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement
Critique Input Shaper graphs and advice. : r/klippers
Input Shaper without effect?! - General Discussion - Klipper
How To Install Klipper On Creality Ender 3 S1: Config And Setup
Klipper input shaper wierd graph - General Discussion - Klipper
Klipper: Input Shaping – Simply Explained
Solved Diode Applications - Objectives In this experiment
Disabling axis when calibrating input shaper - General Discussion - Klipper
FR] Input shapers support in Klipper · Issue #3025 · Klipper3d
R QIDI TECHNOLOGY X-Smart3 3D Printer New Generation of 500mm/s
Klipper: Input Shaping – Simply Explained
Creality vs Klipper Input Shaper Results : r/crealityk1
Input Shaping without Klipper
Input Shaper not working at all - Help is much appreciated! : r/klippers
Klipper: Input Shaping – Simply Explained
Input Shaper without effect?! - General Discussion - Klipper