Janome Rolled Hem D2 Foot (4mm), 9mm - Red Deer Sewing Centre

The Janome 4mm Hemmer Foot for 9mm Machines is used for making rolled edges on light to medium weight fabrics. The channel guide holds the rolled fabric and allows for a straighter hem. The hemming (hemming) foot will allow us to provide a nice, aesthetic finish to dresses, skirts, blouses, shirts, bedding, tablecloths, table runners and curtains. It is designed for sewing light and medium thickness fabrics. Before hemming, fold the edge of the fabric twice to a width of 4 mm and it is good to press it to a length of approx. 3 cm. Then, when sewing, it is enough to guide the fabric evenly, because the guide on the foot will make a perfectly even fold of the fabric itself. The width of the hem after stitching is 4 mm.

Janome Hemmer Feet Set (4mm & 6mm) - Red Deer Sewing Centre

Janome 4mm Rolled Hem Foot for 9mm Machines

Janome Rolled Hemmer Foot #820809014 Sewing Machines

Janome America: World's Easiest Sewing, Quilting, Embroidery

Janome 1/4 Seam Foot w/o Guide, 9mm - Red Deer Sewing Centre

Janome Fashion & Finishing Accessory Kit for 9mm Models - Red Deer

The Rolled Hem Foot is used to stitch the narrow rolled hems usually found on shirt tails, table linens, and along the edges of frills. The Rolled Hem

Rolled Hem Foot (4mm) D2

Janome Hemmer Feet Set (4mm & 6mm) - Red Deer Sewing Centre

Blind hemming can sometimes be a little bit tricky so the blind hem foot goes some way to helping improve this technique. The foot has a metal guide

Blind Hem Foot 825817009 - Janome

Janome 4mm Rolled Hem Foot - 9mm Machines. 202 081 007 Cat. D

D2 Belt Crafting Cheapest Factory

Janome Edge Stitch Foot for 9mm Machines

Janome Piping Foot, 9mm - Red Deer Sewing Centre