By A Mystery Man Writer
Hello, I am in the process of tuning my newly built Prusa i3 and I have some issue finding the right parameters to tweak in order to fix some issues with the infill of my first layers. I am using Repetier firmware/host and Slic3r 0.9.10b. The basic calibration seams quite ok and I am getting very u
How to Fix Under Extrusion: Maintenance and Print Settings
First layer calibration issue where edges are curling but height adjust lines are fine. Happens with all prints. : r/prusa3d
Anyone good at reading first layer calibrations? : r/prusa3d
First Layer Calibration Prusa i3 MK3/s/+ by ArtyL
Prusa I3 MK2 info
First Layer Calibration Prusa MINI by ArtyL
First Layer calibration on the Prusa I3 Mk3 - No Frills
cdn./assets/4e/eb/7f/35/a9/card_pre
First Layer Calibration (i3)
First Layer Calibration (i3)