First Layer Temperature - UltiMaker Cura - UltiMaker Community of

This is one that's had me stumped for a while. In another slicer (S3D), I can set the first layer to be different (hotter) than the following layers. For example, with PLA, I would usually do the first layer 5 C hotter, then on layer 2, reduce it. The Setting seems to point to something I just ca

Build Plate Temperature Initial Layer is ignored · Issue #17233 · Ultimaker/ Cura · GitHub

ultimaker cura - Slicing problem - Slic3r prusa - 3D Printing Stack Exchange

Ultimaker Cura Now Available Page UltiMaker Cura UltiMaker , 45% OFF

Cura for Clay 3D Printing, Overview

Why does the print speed change at specific height? (Using Ultimaker Cura slicer) - 3D Printing Stack Exchange

ultimaker cura - Problem printing circles/holes on Anycubic I3 mega - 3D Printing Stack Exchange

slicing - Ultimaker Cura is adding redundant top/bottom layers - 3D Printing Stack Exchange

Cura all layer start from the corner - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Ultimaker Cura Now Available Page UltiMaker Cura UltiMaker , 40% OFF

Cura First Layer Settings: Initial Layer Simply Explained

I'm using Ultimaker Cura to splice a print for an Ender 3. How do I make the box structure on the bottom right match the one above it, where they both are

1st layer will not continuously print. HELP A NOOB OUT PLEASE! - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Temperature tower - UltiMaker Cura - UltiMaker Community of 3D Printing Experts