Thermistor 100K, Crimped w/ Cables – UltiMachine

This thermistor is used for measuring the temperature of the RepRap extruder.  The thermistor has been crimped with wire leads and a 2-pin male latch housing. The matching cable has been housed with a 2-pin female latch housing on one end, and a 2-pin connector labeled "thermistor" on the other end. The default thermis

RAMPS 1.4 - RepRap

NTC 100K ohm B3950 Thermistor Cartridge

Thermistor 100k ATC Semitec 104GT-2 loose

RAMPS 1.4 알고 쓰자 : 네이버 블로그

NTC 100K ohm B3950 Thermistor Cartridge

RAMPS 1.4 - RepRap

Thermistor - 100k NTC – SeeMeCNC

Acinkeety EBB SB2209 CAN with Pre-Crimped 30-Pin Wire NTC100K Thermistor for Voron StealthBurner 3D Printer Hotend Klipper SB2240 EBB SB2209 CAN with Pre-Crimped 30-Pin Wire High-Performance 32-bit : Industrial & Scientific

CHC Pro 115W NTC 100K B3950 Thermistor

RAMPS 1.3 - RepRap

✔️Upgrade HT-NTC100K Thermistor: package temperature measurement. Head diameter: 3mm, Head length: 15mm ✔️The temperature measurement: -50 °C ~ +350

WINSINN HT-NTC100K Thermistor Sensor, Ender 3 v2 Upgrade 3x15 3950 XH2.54 2Pin, Compatible with Ender 3 5 Pro CR6 CR10 Series 3D Printer Hotend (Pack