Boundary Layer Surface Mesh Can't Be Swept - Meshing - Coreform LLC

Hello, I’m trying to prepare a mesh for CFD and need to add boundary layers to a fluid volume. I have attached the geometry I’m trying to mesh below. test_fluid.cub5 (200.8 KB) When you open it, we have a single volume with boundary layers already defined: This volume seems pretty well suited to meshing a face and then sweeping, so let’s try that: surface 7 size 1.25 mesh surface 7 At this point we are looking pretty good: But when I try to sweep the volume, I get errors: Cubit>vo

Problems with Boundary Layer Meshing Tool - Meshing - Coreform LLC

Meshing with CUBIT - Meshing - Coreform LLC

Meshing problem : r/CFD

High Order (Curved) Grids

Hex Meshing Bug - Meshing - Coreform LLC

PDF) The Cleave and Fill Tool: An All-Hexahedral Refinement

Your Guide to Meshing Techniques for Efficient CFD Modeling

Coreform Cubit: Strategies for solving tricky meshing problems

Unable to create conformal mesh for 3D T-junction - Meshing

Boundary Layer Surface Mesh Can't Be Swept - Meshing - Coreform LLC

Hex Meshing Bug - Meshing - Coreform LLC

Boundary Layer Surface Mesh Can't Be Swept - Meshing - Coreform LLC

Introduction to Coreform Cubit: Hex meshing for beginners with the