Malco Right Angle Drive Access (For HC1/2) – Roofing Tool Shop

Works well with HC1 and HC2 Hole Cutters. May be used to help cut take-off holes in sheet metal duct-work suspended below floor joists or for take-offs from the side of large trunk lines where reaching up and cutting at 90° is desirable.

Malco Right Angle Drive Access (For HC1/2) – Roofing Tool Shop

Cuts 2-12 (51-305 mm) holes in sheet metal including up to 20 gauge galvanized steel Commonly used by HVACR and Roofing Professionals Combination

Malco HC1 2 in. to 12 in. Sheet Metal Hole Cutter Accessory for 1/4 in. or Larger Drill, Multi

Malco Right Angle Drive Access (For HC1/2) – Roofing Tool Shop

Gold Standard” Sheet Metal Hole Cutters and Cutter Bits - Malco Tools

Malco Drill Parts & Attachments at

Cuts 2-12 (51-305 mm) holes in sheet metal including up to 20 gauge galvanized steel Commonly used by HVACR and Roofing Professionals Combination

Malco HC1 2 in. to 12 in. Sheet Metal Hole Cutter Accessory for 1/4 in. or Larger Drill, Multi

HVAC – Roofing Tool Shop

Right angle drill attachment Drill Parts & Attachments at

Malco’s sheet metal hole cutter quickly installs into the chuck of any corded or cordless drill as small as 1/4″ (6.35 mm). The Distinctive Gold Bits,

Malco Hole Cutter

Gold Standard” Sheet Metal Hole Cutters and Cutter Bits - Malco Tools